Warnung
You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .Safety information
Warnung
Asyril cannot be held liable for damage to property or injuries to people caused by
failure to follow the instructions specified in the „Safety instructions“ paragraph. It is the customer’s
responsibility to inform the personnel concerned.
Bemerkung
All dimensions and measurements in this manual are expressed in millimeters (mm).
General instruction
Gefahr
Be sure that all power sources and other cables to the unit are disconnected before working on
the product.
Gefahr
Do not unscrew the housing of the system controls. Serious injury or death could result
from electric shock. Only authorized personnel from Asyril SA are allowed to access this part of the system for
maintenance or for repair.
Gefahr
Never modify the product. Unauthorized modification may cause the product to malfunction, resulting
in injury, electric shock, fire, etc.
Gefahr
Do not use the product in a place where the main unit or controller may come in contact with
water or oil droplets.
Gefahr
The active elements inside the EYE+ make the surfaces shown in the picture below (blue surface)
capable of heating up to 50°C in extreme use cases. It is the responsibility of customers to document their own application and
instruct employees on procedures to avoid contact with these surfaces.
Abb. 1 Surface of EYE+ that could become hot (in blue)
Disposal
When the product reaches the end of its service life, it must disposed of in accordance with regulations concerning industrial waste.
Bemerkung
All applicable laws, regulations, and standards must be observed when disposing of the product.
Maintenance and repair
Warnung
No maintenance operation must be performed inside the product. To perform internal
maintenance operations, please contact Asyril. Failure to respect this requirement will invalidate the warranty.
Gefahr
Never use the system when it is damaged. Check that you have resolved the problem before
restarting the machine.
Bemerkung
Cleaning the optical parts: Visually inspect the optical parts (camera, lens, lighting, etc.)
and clean if necessary.
Transportation, handling and installation
Packaging of the product, transportation and handling
The product must be transported in accordance with the specifications indicated on the package (top, bottom, fragile, etc.). In addition, the following points must be strictly respected:
Take adequate precautions during handling.
Do not climb on the package.
Never place heavy objects on the package.
Take particular care to avoid damaging the product during transportation.
Unpacking instructions
Before unpacking:
Ask the transporter to be present at the time of unpacking.
Pay particular attention to the external condition of the product.
If any damage is noted, do not sign the receipt and contact Asyril immediately.
Bemerkung
If the products received do not match your delivery note, or are delivered in poor condition, do
not sign the receipt and contact Asyril as soon as possible.
Installation and storage environment
The EYE+ Controller system must be used under the following conditions:
Characteristic |
Value |
|---|---|
Storage Temperature |
+5°C to 40°C |
Operating Temperature |
+5°C to 40°C |
Humidity |
Operating: 30% to 85% |
Ingress Protection |
IP30 |
The camera must be used under the following conditions:
Characteristic |
Value |
|---|---|
Storage Temperature |
-30 to 60°C |
Operating Temperature |
-20 to 55°C ambient |
Humidity |
Operating: 20% ~ 80%, relative, non-condensing |
Shock and Vibration |
DIN EN 60068-2-27, DIN EN 60068-2-64, DIN EN 60068-2-6 |
Ingress Protection |
IP67 |