Warnung

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .

TCP programming guide

The host computer communicates with the EYE+ Controller through TCP/IP protocols. The EYE+ Controller acts as a server and the host communicates as a client. The server does not send constantly data to the client, it only responds to its requests.

The default TCP/IP configuration to enable communication between EYE+ and your robot/PLC through EYE+‘s robot Ethernet port is presented in Tab. 30.

Tab. 30 EYE+ Controller default Robot Ethernet configuration

Ethernet port

IP address

Subnet mask

Port

Robot

192.168.0.50

255.255.255.0

7171

Bemerkung

Make sure to have properly connected your robot/PLC to EYE+. Refer to section Robot/PLC.