Warnung

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .

Camera

Access the camera configuration through CONFIGURATION and Camera.

../../_images/camera_configuration_interface.png

Abb. 121 Camera configuration interface

The camera configuration card informs you about the current state of the Camera configuration wizard wizard and allows you to open it.

Three variants of the interface are possible:

  • No camera configuration performed (Abb. 122)

../../_images/no_camera_configuration.png

Abb. 122 No camera configuration performed

  • Camera configuration in progress (Abb. 123)

../../_images/camera_configuration_in_progress.png

Abb. 123 Camera configuration in progress

  • Camera configuration already performed (Abb. 124)

../../_images/camera_configuration_access_done.png

Abb. 124 Camera configuration already perfomed

If the camera configuration was already performed (Abb. 124), some information regarding last camera configuration is available:

  • Date of last configuration: Date of when the last camera configuration was performed.

  • Working distance: Measured distance between the Asycube and the camera’s lens.

  • RMS Error: RMS error of last distortion correction.

  • px/mm scale or px/in scale: Scale between pixels and millimeters/inches.


Access camera configuration wizard

Click on START CAMERA CONFIGURATION WIZARD or OPEN CAMERA CONFIGURATION WIZARD to access the Camera configuration wizard wizard.