Warnung
You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .Parameters
Parameters are accessible through the commands get_parameter <parameter> and set_parameter <parameter> <value>. The parameters can be read from any EYE+ state. However the parameters can only be changed when EYE+ is in production state.
Wichtig
Changing the parameters value will affect the behavior of the EYE+ commands.
Parameter |
Type 1 |
Valid value |
Default value |
|---|---|---|---|
state |
RO |
string |
<none> |
recipe |
RO |
string |
<none> |
timeout |
R/W |
float |
30.0s |
image_after_send |
R/W |
true/false |
false |
is_prepared |
RO |
true/false |
false |
n_parts_prepared |
RO |
int |
0 |
part_quantity |
R/W |
int |
1 |
- 1
RO: Read Only; R/W: Read and Write
state
It is the system state (production, recipe_edition, camera_configuration, handeye_calibration).
start production 21180
200
get_parameter state
200 production.idle
recipe
This command returns the identifier and name of the recipe currently running in production.
Bemerkung
If you did not start EYE+ in production, the get_parameter recipe response will be: 200 no recipe.
start production 21180
200
get_parameter recipe
200 21180 'Recipe_name'
timeout
It is the timeout (in seconds) when calling the get_part command. The command stop <state> is sent if the timeout is exceeded during a get_part.
get_parameter timeout
200 30.0
set_parameter timeout 12
200
get_parameter timeout
200 12.0
image_after_send
It forces to acquire an image after a part is picked. Each time you call the get_part or prepare_part commands, the system will automatically take an image just before. It is used to correct the coordinates of the good candidates already found (stored in memory) if you know that the parts have moved in the meantime due to some external disturbance.
get_parameter image_after_send
200 false
set_parameter image_after_send true
200
get_parameter image_after_send
200 true
is_prepared
It returns status of the last prepare_part.
true if enough parts are prepared
false if not enough parts are prepared
get_parameter is_prepared
200 false
n_parts_prepared
It returns the number of parts prepared during the last prepare_part.
get_parameter n_parts_prepared
200 0
part_quantity
It is the number of parts requested by prepare_part and get_part each time it takes an image. If this number of parts is not found during image acquisition, then the get_part or prepare_part will start again (vibration + image acquisition) until this number of parts is found.
get_parameter part_quantity
200 1
set_parameter part_quantity 8
200
get_parameter part_quantity
200 8