Warnung

Sie lesen eine alte Version dieser Dokumentation. Wenn Sie aktuelle Informationen wünschen, schauen Sie bitte unter 5.0 .

Plugin installation

Step 1: Check robot software

The plugin uses socket messaging over TCP/IP protocol. You must have the optional „User Socket Msg“ software (R648) installed on your robot to enable socket communication.

If it is correctly installed, the following information should be displayed on the IPendant touch under the path MENU/STATUS/Version ID/Media and select NEXT/ORDER FI.

../../../_images/r648.png — Abb. 202 User Socket Messaging - R648

Wichtig

If the software is not installed on your robot, please contact FANUC support to get it.

Step 2: Download the plugin

Download the plugin zip file fanuc-eyeplusPlugin-version.zip here. It must contain 9 p-code files (extension .pc).

eye_check_last_error.pc
eye_comm1.pc
eye_comm2.pc
eye_configure.pc
eye_get_part.pc
eye_prepare_part.pc
eye_raw_command.pc
eye_start_production.pc
eye_stop.pc

Step 3: Install the plugin on your robot

Unzip the fanuc-eyeplusPlugin-version file and save the 9 files on a USB key.

Warnung

Your USB key must be formatted to FAT or FAT32 (File Access Tables) to be detected by the controller.

Connect the USB key to the IPendant touch of the robot. On the IPendant touch, go to MENU/FILE/UTILE/Set Device/Select your device. Then, for each file, select the file and click LOAD.

../../../_images/load_files.png — Abb. 203 Select the *.pc* file and click on `LOAD`

../../../_images/loaded_files.png — Abb. 205 Wait until the message `Loaded UT1:\EYE_CHECK_LAST_ERROR.PC` is displayed on the IPendant touch.

Step 4: Check if the files are correctly installed

From the IPendant touch, go to SELECT/[TYPE]/KAREL Progs. Then check if the 9 files are listed in this window as shown in Abb. 206.

Bemerkung

The version of the plugin you downloaded must be displayed on the side.

../../../_images/check_files_installation.png — Abb. 206 Check the installation of the files