Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .

Parameters

Parameters are accessible through the commands get_parameter <parameter> and set_parameter <parameter> <value>. The parameters can be read from any EYE+ state. However the parameters can only be changed when EYE+ is in production state.

Important

Changing the parameters value will affect the behavior of the EYE+ commands.

Table 27 List of parameters
Parameter	Type 1	Valid value	Default value
state	RO	string	<none>
recipe	RO	string	<none>
timeout	R/W	float	30.0s
image_after_send	R/W	true/false	false
is_prepared	RO	true/false	false
n_parts_prepared	RO	int	0
part_quantity	R/W	int	1
version	RO	string	<none>

1: RO: Read Only; R/W: Read and Write

state

It is the system state (e.g. error, production, recipe_edition, camera_configuration, handeye_calibration). States are described in EYE+ states.

start production 21180
200
get_parameter state
200 production.idle

recipe

This command returns the identifier and name of the recipe currently running in production.

Note

If you did not start EYE+ in production, the get_parameter recipe response will be: 200 no recipe.

start production 21180
200
get_parameter recipe
200 21180 'Recipe_name'

timeout

It is the timeout (in seconds) when calling the get_part command. The command stop <state> is sent if the timeout is exceeded during a get_part.

get_parameter timeout
200 30.0
set_parameter timeout 12
200
get_parameter timeout
200 12.0

image_after_send

It forces to acquire an image after a part is picked. Each time you call the get_part or prepare_part commands, the system will automatically take an image just before. It is used to correct the coordinates of the good candidates already found (stored in memory) if you know that the parts have moved in the meantime due to some external disturbance.

get_parameter image_after_send
200 false
set_parameter image_after_send true
200
get_parameter image_after_send
200 true

is_prepared

It returns status of the last prepare_part.

true if enough parts are prepared
false if not enough parts are prepared

get_parameter is_prepared
200 false

n_parts_prepared

It returns the number of parts prepared during the last prepare_part.

get_parameter n_parts_prepared
200 0

part_quantity

It is the number of parts requested by prepare_part and get_part each time it takes an image. If this number of parts is not found during image acquisition, then the get_part or prepare_part will start again (vibration + image acquisition) until this number of parts is found.

get_parameter part_quantity
200 1
set_parameter part_quantity 8
200
get_parameter part_quantity
200 8

version

Return the software version of EYE+.

get_parameter version
200 1.3.0