Warning
You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .TCP programming guide
The host computer communicates with the EYE+ Controller through TCP/IP protocols. The EYE+ Controller acts as a server and the host communicates as a client. The server does not send constantly data to the client, it only responds to its requests.
The default TCP/IP configuration to enable communication between EYE+ and your robot/PLC through EYE+’s robot Ethernet port is presented in Table 30.
Ethernet port |
IP address |
Subnet mask |
Port |
|---|---|---|---|
Robot |
192.168.0.50 |
255.255.255.0 |
7171 |
Note
Make sure to have properly connected your robot/PLC to EYE+. Refer to section Robot/PLC.