Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

TCP programming guide

The host computer communicates with the EYE+ Controller through TCP/IP protocols. The EYE+ Controller acts as a server and the host communicates as a client. The server does not send constantly data to the client, it only responds to its requests.

The default TCP/IP configuration to enable communication between EYE+ and your robot/PLC through EYE+’s robot Ethernet port is presented in Table 31.

Table 31 EYE+ Controller default Robot Ethernet configuration

Ethernet port	IP address	Subnet mask	Ports
Robot	192.168.0.50	255.255.255.0	7171, 171, 17171

Note

Make sure to have properly connected your robot/PLC to EYE+. Refer to section Robot/PLC.

Note

EYE+ Controller listens to the three ports defined in Table 31 simultaneously, we recommend to choose 7171, however depending on your requirements you might choose another one from the list.