警告

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

5.2 Pick Angle Positioning

The angle is defined on the pick point defined in the previous step.

../../../../_images/pick_angle_teaching_pick_angle_positioning.png

図 86 Pick Angle Teaching - Pick Angle Positioning

Part with multiple pick angles

Some parts can have multiple pick angles due to symmetries, as illustrated in 図 87. By specifying the number of pick angles, the robot will be able to pick the part from any of these angles. This is useful when one of the pick angles is not possible in case of contact with another part or with the edges of the Asycube. If this happens, one of the other pick angles will be used.

To specify the number of pick angles, you must check the box "My part can be picked from multiple angles" and enter the correct number of angles. Each angle will be represented by an arrow on the image.

../../../../_images/multiple_angles.png

図 87 Part with 4 pick angles

Pick angle positioning

Rotate the X/Y frame until it is aligned in the right direction for robot pickup.

注釈

This operation must be done carefully because it determines the accuracy of the RZ angle that will be sent to the robot.

Feature masking

../../../../_images/pick_angle_teaching_features_masking.png

図 88 Feature masking so that the orientation of the pick angle is aligned with the long side of the part

The objective of the feature masking step is to define the reference features (residual features after masking) that will be used as a model to orient the angle of the pick.

Not all features are relevant to define the reference model.

  • Features at the same height: Features that are not placed at the same level as the pick point must be masked out. Use only one height of features (e.g. the same height used for the pick point). Adding features that are not at the same level may alter the accuracy of the positioning of the pick angle due to parallax (these features on a different level will not always have the same relative position depending on the position of the part in the Asycube).

  • Reproducible features: It is essential that the reference model reflects a general description of the candidates. Any features that are not reproducible from one candidate to another must be masked.

  • Enough feautures: There must be enough features to ensure that there is only one possible pick angle identified by the algorithm.

Use the brush brush to mask undesired features.

Tip

You can import the mask used to mask the features of the pick point by clicking on IMPORT.