Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

1.3 Plate Separation

In this step, you have to tell the system where the plate separation is.

Fig. 250 Starting up - Plate Separation

For this, you get a live image of the Asycube with auto-exposure enabled (all available lighting sources can be switched on/off from here), as well as a movable line to be placed above the separation. That line can either be vertical or horizontal depending on your plate and can be changed using the toolbox. Once you have selected the correct orientation, drag the line above the Asycube separation so it is approximately in the middle of it.

You may also rename each part if you so desire. That name will be used for the remaining steps.