警告

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

Force take image

The scenario with the command force_take_image is used when you know that the parts on the Asycube will move because of some external disturbances. The disturbances can occur during the pick or place of a part, or simply during a robot movement.

The command force_take_image is then useful to ensure the coordinates of the parts by taking another image after the known disturbances. Refer to 図 158 for a straightforward integration with a get_part command.

注釈

If the parameter can_take_image is set to false, the command force_take_image will not start.

../../../_images/force_take_image_1.png

図 158 force_take_image with get_part: 2 possibilities

../../../_images/force_take_image_2.png

The left scenario in 図 158 follows these steps:

  1. [Move robot out of field of view]: Before calling the get_part command, you have to ensure that nothing obstructs the camera view.

  2. [get_part]: Call the get_part command, it will either make the Asycube vibrate and take a picture, or send you directly the coordinates of a part.

  3. [Pick part]: Pick the part. When the part is picked up, the robot touches the Asycube and makes the remaining parts move.

  4. [force_take_image]: Force EYE+ to take an image to adapt the coordinates already stored in memory with their new position.

  5. Start again from step 1. The cycle stops when EYE+ receives the command stop production.