Avertissement

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

System

Access the network interfaces settings through CONFIGURATION and System.

../../_images/configuration_system.png

Fig. 142 System upgrade

This page gives you the possibility to perform 3 actions to your system:

Note

System upgrade, backup and restore cannot be performed while being in other state than Ready.

System upgrade

Before upgrading the system, it is strongly recommended to create a system backup.

Periodic upgrades will be available. System upgrade allows you to obtain the latest EYE+ functionalities. The file format of the new version provided by Asyril is a .upgrade.

Click on START SYSTEM UPGRADE to access the upgrade wizard and follow the instructions.

Once the upgrade has stared, you will have to provide this new version to your system and wait for the end of upgrade process and system reboot. When the system enters the upgrading state, the status led blinks faster (5Hz) and then when the system reboots during the upgrade, the led will be off.

The upgrade takes less than 15 minutes to complete. Step 3 can take around 7 minutes and rebooting could take around 5 minutes depending on your system configuration.

../../_images/system_upgrade.png

Fig. 143 System upgrade

Important

We advise you to perform a System backup before upgrading your system. Asyril will not be responsible for any loss of data if a backup was not properly performed before the upgrade.

Avertissement

To ensure that your recipes are compatible with the new upgrade, please refer to the release notes. If you have any questions, please contact the support team.

System backup

You can use this interface to create a system backup. The backup saves all your recipes and configurations:

Note

Recipe identifiers do not change when backup is made.

This backup is saved in a .eyeplus.backup file.

To create a backup you must plug an USB storage device into one of the two USB ports and click on refresh to detect the drive.

Next, select the USB device and click on START BACKUP. This may take some time to complete.

../../_images/system_backup.png

Fig. 144 System backup

Note

We advise you to back up your system frequently.

System restore

From here you can restore your system from a backup file.

To perform a restore, insert a USB drive containing a backup (file .eyeplus.backup) an click on SELECT BACKUP FILE to select the right backup file.

Then, confirm the selection and wait for the restore to complete.

Avertissement

It is not possible to retrieve recipes and configurations that were stored in your EYE+ before the restore. They will be completely erased by the restore.

../../_images/system_restore.png

Fig. 145 System restore