Warning
You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .Asycube
The electrical interfaces of the Asycube are described in Asycube Electrical Interfaces.
Asycube connection
Connect the Asycube Ethernet communication to the EYE+ Controller Asycube RJ45 Ethernet port with an Ethernet cable. The Ethernet cable should be at least Cat5e SF/UTP.
Note
This cable can be supplied on request by Asyril in different lengths (2m, 5m, 10m, 15m, 20m).
Asycube specifications
The default Asycube port configuration on the EYE+ Controller side is the one presented in Table 14.
Ethernet port |
IP address |
Subnet mask |
|---|---|---|
Asycube |
192.168.127.1 |
255.255.255.0 |
Important
If you changed the IP address of your Asycube, EYE+ will not be able to connect to it. You can refer to section Asycube IP settings to check the Asycube connection.
If your Asycube does not have the correct IP address, refer to recover IP address to set it back to its default IP address.