Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

Electrical interfaces

The EYE+ Controller must be connected to :

  • Power supply

  • Asycube

  • Camera

Furthermore, several other interfaces are available to connect:

  • Robot or PLC for production

  • Computer or company network for configuration

  • Frontlight

  • Hopper(s) (Asyfill smart hopper, standard hopper or other feeding devices)

../_images/global_connectic_cover_1.png

Fig. 46 EYE+ overall wiring diagram (cover rev. 1)

Note

Communication cables can be ordered in different lengths depending on your needs.

Connector Overview

The EYE+ Controller has connectors on both sides to connect the devices mentioned above.

../_images/front_bottom_connections_cover_1.png

Fig. 48 EYE+ Controller connections (cover rev. 1)

(A) Visual Signals and Reset button

(B) Ethernet Connections RJ45 Ethernet ports

(C) GPIO connector

(D) Frontlight connector

(E) Power supply connector

(F) USB connectors, used for System backup and System restore

(G) Optional Fieldbus Module

Important

The USB connectors (F) are intended for backup and restore purpose only. Do not use these ports to power any external devices (e.g. tablet, PC, etc). Failure to comply with this instruction may result in permanent damage to the EYE+ Controller.