Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.0 .

EYE+ Studio 3.1

EYE+ Studio 3.1.0

Released on 2022-06-02

New Features

EYE+ Controller

  • Support new hardware configuration for AVN series.

Qualification wizard

A few modification has been implemented on the qualification wizard to improve it’s readability and usability.

  • Display not rounded data to prevent losing information

  • Display the scale on the mini-plots

  • Replace the Pick Rate graph that displayed the pick rate for the current simulation over time by a new graph that displays the average pick rate depending on the robot cycle time.

Communication configuration

A new Communication configuration is available in Configuration centralizing the configuration settings of multiple devices. This replaces the previous Network configuration.

Resolved Issues

General

  • System upgrade: Fix an issue where after the upgrade Google Chrome says it failed even if the upgrade was successful.

Recipe wizard

  • 2.1 Acquisition settings: Fix the formula that calculated the initial image settings. This prevent having “Image not available” error when using non standard Lighting settings.

  • 4.2 Pick Point Positioning: Fix an issue where snapping of the pick point was not centered on the guideline.

  • 6.1 Gripper Drawing: Fix the snapping lines that were a bit outside of the shapes.

  • 7.1 Platform Tuning: Fix an issue where sometimes the continuous vibration appeared jerky or stopped after changing the parameters.

  • 7.3 Vibration Sequence: Fix an issue where in parallel mode the text “Platform” and “Hopper” were inverted.

  • 7.3 Vibration Sequence: Fix an issue where the “after” vibration sequence image could disappear just after being displayed.