EYE+ Studio 3.1

EYE+ Studio 3.1.0

Released on 2022-06-02

New Features

EYE+ Controller

Support new hardware configuration for AVN series.

Qualification wizard

A few modification has been implemented on the qualification wizard to improve it’s readability and usability.

Display not rounded data to prevent losing information
Display the scale on the mini-plots
Replace the Pick Rate graph that displayed the pick rate for the current simulation over time by a new graph that displays the average pick rate depending on the robot cycle time.

Communication configuration

A new Communication configuration is available in Configuration centralizing the configuration settings of multiple devices. This replaces the previous Network configuration.

Resolved Issues

General

System upgrade: Fix an issue where after the upgrade Google Chrome says it failed even if the upgrade was successful.

Recipe wizard

2.1 Acquisition settings: Fix the formula that calculated the initial image settings. This prevent having “Image not available” error when using non standard Acquisition lighting settings settings.
4.2 Pick Point Positioning: Fix an issue where snapping of the pick point was not centered on the guideline.
6.1 Gripper Drawing: Fix the snapping lines that were a bit outside of the shapes.
7.1 Platform Tuning: Fix an issue where sometimes the continuous vibration appeared jerky or stopped after changing the parameters.
7.3 Vibration Sequence: Fix an issue where in parallel mode the text “Platform” and “Hopper” were inverted.
7.3 Vibration Sequence: Fix an issue where the “after” vibration sequence image could disappear just after being displayed.