Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 5.1 .

Purge plate

EYE+ allows you to take full advantage of your optional Asyril purging system for removing any excess of parts on the platform during production.

../../../../_images/purge_plate.png

Fig. 247 Production scenario with purge plate

  1. [Start production <id>]: Start the production for the first part.

  2. [Pick parts]: Run your production for this part for as long as you need, using either a scenario detailed previously or your own.

  3. [stop production]: Whenever you feel like a purging of the Asycube plate is required (e.g. when the get_part command times out), stop the production to get EYE+ ready to purge the parts from the Asycube.

  4. [start purge <id>]: Get EYE+ in the purge state with the correct vibration parameters for this part as defined in the recipe.

  5. [purge plate <duration>]: Call the purge plate command to start the purge sequence.

  6. [stop purge]: Get EYE+ ready to use a new recipe for production.

  7. Start over from step 1 to resume production from a clean platform.